Sharing insights and ideas that inspire innovation.
Introduction: Understanding Vacuum Levels A vacuum is defined as an area with a pressure lower than that of the atmosphere, which is approximately 1,013 mbar
Over-specifying vacuum chamber surface finish specifications, or applying the same strict requirement to the entire chamber, can quickly raise your costs. Achieving tight Ra targets
Custom vacuum chambers rarely move through a shop as quickly as standard, off-the-shelf components — and for good reason. Every project brings its own mix
It is not a little setback if your vacuum chamber does not pass the leak test after final assembly. It would require weeks of labor
You send your drawings to a vacuum chamber manufacturer, receive a quote, and place the order. Weeks later, a question comes back that changes the
The goal of this guide is not simply to make vacuum chambers cheaper. It is to help you cut down unnecessary cost drivers that do
Picking a pump for a vacuum chamber sounds simple until you are staring at a datasheet with half a dozen technologies on it, none of
Vacuum chamber sealing keeps unwanted gas from entering a chamber while pumps remove gas from inside. The seal affects pump-down speed, leak rates, cleaning, temperature
You already know the semiconductor industry forms the foundation for breakthroughs in electronics, computing, and telecommunications. Fabricating high-performance electronic components, including integrated circuits, microchips, and
Vacuum chamber sealing keeps unwanted gas from entering a chamber while pumps remove gas
Sharing insights and ideas that inspire innovation.
Introduction: Understanding Vacuum Levels A vacuum is defined as an area with a pressure lower than that of the atmosphere, which is approximately 1,013 mbar
Over-specifying vacuum chamber surface finish specifications, or applying the same strict requirement to the entire chamber, can quickly raise your costs. Achieving tight Ra targets
Custom vacuum chambers rarely move through a shop as quickly as standard, off-the-shelf components — and for good reason. Every project brings its own mix
It is not a little setback if your vacuum chamber does not pass the leak test after final assembly. It would require weeks of labor
You send your drawings to a vacuum chamber manufacturer, receive a quote, and place the order. Weeks later, a question comes back that changes the
The goal of this guide is not simply to make vacuum chambers cheaper. It is to help you cut down unnecessary cost drivers that do
Vacuum chamber sealing keeps unwanted gas from entering a chamber while pumps remove gas
