Sharing insights and ideas that inspire innovation.
Three factors determine the extent of shipping damage: the location of support, the strength of the ties, and the availability of pre- and post-trip measurements.
A vacuum chamber may look perfectly fine after welding. The ports are in place, the lid fits, and everything seems ready for testing. But when
Introduction: Understanding Vacuum Levels A vacuum is defined as an area with a pressure lower than that of the atmosphere, which is approximately 1,013 mbar
Over-specifying vacuum chamber surface finish specifications, or applying the same strict requirement to the entire chamber, can quickly raise your costs. Achieving tight Ra targets
Custom vacuum chambers rarely move through a shop as quickly as standard, off-the-shelf components — and for good reason. Every project brings its own mix
It is not a little setback if your vacuum chamber does not pass the leak test after final assembly. It would require weeks of labor
You send your drawings to a vacuum chamber manufacturer, receive a quote, and place the order. Weeks later, a question comes back that changes the
The goal of this guide is not simply to make vacuum chambers cheaper. It is to help you cut down unnecessary cost drivers that do
Picking a pump for a vacuum chamber sounds simple until you are staring at a datasheet with half a dozen technologies on it, none of
Three factors determine the extent of shipping damage: the location of support, the strength
Sharing insights and ideas that inspire innovation.
Three factors determine the extent of shipping damage: the location of support, the strength of the ties, and the availability of pre- and post-trip measurements.
A vacuum chamber may look perfectly fine after welding. The ports are in place, the lid fits, and everything seems ready for testing. But when
Introduction: Understanding Vacuum Levels A vacuum is defined as an area with a pressure lower than that of the atmosphere, which is approximately 1,013 mbar
Over-specifying vacuum chamber surface finish specifications, or applying the same strict requirement to the entire chamber, can quickly raise your costs. Achieving tight Ra targets
Custom vacuum chambers rarely move through a shop as quickly as standard, off-the-shelf components — and for good reason. Every project brings its own mix
It is not a little setback if your vacuum chamber does not pass the leak test after final assembly. It would require weeks of labor
Three factors determine the extent of shipping damage: the location of support, the strength
